Junction Box Type KP-4 TECHNICAL MANUAL Flintec GmbH Bemannsbruch 9 74909 Meckesheim GERMANY www.flintec.
RIGHTS AND LIABILITIES All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, mechanical, photocopying, recording, or otherwise, without the prior written permission of Flintec GmbH No patent liability is assumed with respect to the use of the information contained herein. While every precaution has been taken in the preparation of this book, FLINTEC assumes no responsibility for errors or omissions.
INTRODUCTION AND TECHNICAL DATA The Polyester junction box is designed for the parallel connection of up to 4 load cells. Type KP-4 No. of load cells up to 4 Housing size 75 x 230 x 50 mm Inputs 4x M12 Output 1x M16 The junction box type KP can be connected to the instrumentation with a shielded 6-wire signal cable. The corner correction is done with resistors.
After all conductors have been soldered to the printed circuit board, the cable glands must be tightened. Please verify that all cable glands are tight and the cable is fully stress relieved. Important: To prevent any deterioration of the signals it is recommended to clean the printed circuit-board from splash of solder, colophonium, grease and other dirt after the soldering works have been finalised. Use spirit or similiar.
