Junction Box Type KPFD-8 for digital load cells TECHNICAL MANUAL Flintec GmbH Bemannsbruch 9 74909 Meckesheim GERMANY www.flintec.
RIGHTS AND LIABILITIES All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, mechanical, photocopying, recording, or otherwise, without the prior written permission of Flintec GmbH No patent liability is assumed with respect to the use of the information contained herein. While every precaution has been taken in the preparation of this book, FLINTEC assumes no responsibility for errors or omissions.
INTRODUCTION AND TECHNICAL DATA The Polyester junction box is designed for the parallel connection of up to 8 digital load cells. Type KPFD-8 No. of load cells up to 8 digital LC Housing size 100 x 320 x 81 mm Inputs 8x M16 Output 1x M16 The junction box type KPFD is special designed for weigh bridges and silos including surge arrestors for lightning protection. It can be connected to the instrumentation with a special shielded cable (3x twisted pair cable, AWG24, and shield according DIN 47 100).
OUTPUT CABLE CONNECTION The signal cable (connection between junction box and the following electronics) should be a 6 – wire shielded cable (3x twisted pair cable, AWG24, and shield according DIN 47 100). The cable length should not exceed 100 m. Depending on type and manufacturer signal cables may have different colours. Therefore make your own choice.
