Installation Manual

TV ONLY
Check that you do not have a STB / cable box. Many facilities
install their boxes attached to the TV or on a wall. If you see a
STB, go to TV and STB.
1. TV Only mode: press and hold TV till light solid, then 970;
light ashes off;
2. Test the preset: press Vol and CH. If working, go to Favs. If
not working:
3. Locate your brand TV in the code list, then:
a. press and hold TV till light solid, then enter the code.
Light turns off. Test CH and VOL. If working go to Favs.
If not working, try the next code (if no codes work, go to
Code Search);
4. Favorites: TV Only has two options. We recommend (a):
a. Set Favs in TV. Use your TV remote: Menu>Settings> Add
/ Delete channels (or something similar according to your
TV interface), set your list accordingly;
b. Set Favs in Flipper: Press and hold TV and ADD at same
time till solid, enter channels: 123-ADD; 456-ADD; etc.
c. Press TV to exit, test. If not working, then use (a).
Note: many cable companies use sub-channels like 4-1 or 4.1.
Many codes do not have this signal. Try other codes until a
match is found, or use Set Favs in the TV (above).
4