Installation Manual

TV AND STB INSTALLATIONS

Flipper is preset to many devices. First we test the preset.

1. Set TV: press VOL to test preset. If working, go to STB.

If not:

a. Press and hold TV till light turns solid, then enter the

code for your brand - test VOL; If it doesn’t work, then

try next code; If no codes work, go to Code Search.

2. Set STB: press CH to test preset. If working, go to Favs.

If not, then:

a. Press and hold STB till light turns solid, then enter code

for your brand (codes can also be listed by manufacture

of the box). If working, go to Favs. If not, try next code.

If no codes work, go to Code Search.

3. Favorites: if desired:

CH +- scrolls through Favorites; 0-9 work as normal. Make a

list of channels you want to save - channels scroll in the order

they are programmed.

Flipper has two channel entry formats. The format depends

on your box and may require trial and error. One format uses

the box’s OK/ Enter signal, which is LC in Flipper. This may

change channels faster. The other does not use OK / LC.

Always let the channel change before pressing CH again:

Only program two channels to test format;

If a search box appears when using 0-9 to manually enter

channels, then it requires the LC; (Xnity, Contour)

Continued