Installation Manual

CODE SEARCH

Start with the TV and STB on. Code search sends codes from

the database to your TV or STB to search for a match. When the

device turns off, a match is found.

1. Press and hold the device you want to search (TV or STB) till

light solid, then enter code for region;

a. US / Canada: enter 962;

b. UK / EU / AUS / NZ enter 961;

2. Press and release On/Off. The light ashes, sending 15 codes

to the TV;

3. Either: the device turns off, or the light turns solid. If it turns

off, then there is a match in the batch:

a. If the TV turns off, wait till light stops ashing. Then

slowly press and release the CH - (down) to send one

code at a time until the TV turns back on.

b. If the light turns solid (TV does not turn off), then press

On/Off again to send another batch.

4. Once the TV turns back on, press and release TV (or STB).

Test other functions.

Note: If your home region did not turn up a match, try the other

region. Many devices share codes.