Installation Guide

1. Drill the appropriate hole size.
2. Flip the metallic head of the FlipToggle
®
as shown, in order
for it to be aligned and secured onto the strap.
3. Insert the FlipToggle
®
into the drilled hole.
4. When completely inserted, pull the strap towards you which will
ip the toggle at against the back of the wall.
5. Hold the strap towards you while pushing the cap until
reasonably tightened against the wall.
6. Place your thumb on the strap next to the cap. Bend downward
sharply to snap off the excess of the strap ush with the wall.
7. Insert the bolt through the xture, into the anchor and tighten it
securely to the metallic head.