Specifications

1. Check the selected location for the unit. A clear,
flat area with suitable clearance behind the panel
is required.
2. Fix the supplied mounting template to the selected
location, using masking or self-adhesive tape.
3. Using a suitable hole saw (the size is indicated on
the template), make a hole in each corner of the
cut-out area.
4. Using a suitable saw, cut along the inside edge of
the cut-out line.
5. Ensure that the unit fits into the removed area and
then file around the rough edge until smooth.
6. Drill 4 holes as indicated on the template to accept
the fixings.
7. Remove the backings from the supplied gasket.
8. Place the gasket in position on the back of the unit
and press firmly onto the flange.
9. Connect the power, and other cables to the unit.
10. Slide the unit into place and secure using the fixings
provided.
11. Attach the front bezel.
Note:
The supplied gasket provides a seal between the
unit and a suitably flat and stiff mounting surface or
binnacle. The gasket should always be used. It may
also be necessary to use a marine-grade sealant if
the mounting surface or binnacle is not entirely flat
and stiff or has a rough surface finish.
Attaching the front bezel
After installation of the Radio the front bezel can be
attached following the steps below.
The following procedure assumes that the unit has
already been mounted in position.
1. Orientate the bottom-right side of the bezel under
the bottom-right side of the unit, ensuring that the
clips along the bottom edge of the bezel latch into
position.
2. Ensure the bezel is correctly aligned with the unit,
as shown.
3. Apply firm but even pressure to the bezel along the:
i. Outer edges - work from the sides upwards and
then along the top edge, to ensure that it clips
securely into position.
ii. Inner edges - ensure that the bezel sits flat.
4. Check that all control buttons are free to operate.
Fistmic mounting
The Fistmic can be mounted by following the steps
below. Whilst only the Fistmic is pictured, you can
also mount the Handset using the same Hook plate
(mounting clip).
Before mounting the unit, ensure that you have:
• Selected a suitable location, ensuring there is nothing
behind the mounting surface that may be damaged
when drilling.
• Identified the cable connections and route that the
cables will take.
1. Check the selected location for the Hook plate,
a clear flat area is required, with sufficient space
around it to place and remove the Fistmic / Handset
and coiled cable.
2. Using a pencil, offer up the Hook plate to the desired
location and mark the location of the screw holes
on the mounting surface.
3. Drill the mounting holes using a suitable size drill bit.
4. Hold the Hook plate in place and secure using the
screws provided.
5. Hook the Fistmic / Handset over the Hook plate and
gently push down until it clicks into position.
Important:
• The Fistmic can only be hooked and unhooked
from the Hook plate when held vertically.
• Drill bit, tap size and tightening torque is
dependent on the thickness and type of material
the unit is to be mounted on.
32
81381-3-en-US_A5_PRINT.pdf 32 5/4/2020 3:26:31 PM