Specifications

Mounting options
The product can be mounted in the following
configurations.
1. Bracket mount — Table top
2. Bracket mount — Overhead
3. Bracket mount — Bulkhead
4. Panel mount
Bracket mounting
Follow the steps below to mount the product on it’s
bracket.
Before mounting the unit ensure that you have:
• Selected a suitable location, ensuring there is nothing
behind the mounting surface that may be damaged
when drilling.
• Identified the cable connections and route that the
cables will take.
• Attached the front bezel.
1. Mark the location of the bracket mounting holes on
the mounting surface.
2. Drill holes for the mounting fixings using a drill with
a suitable sized drill bit.
3. Use the fixings provided to attach the bracket
securely to the mounting surface.
4. Attach the unit to the bracket and secure in place
using the bracket mounting knobs.
Note:
Drill bit, tap size and tightening torque is dependent
on the thickness and type of material the unit is to
be mounted on.
P
anel mounting — Ray53
Removing the mounting hole covers
Before the radio can be panel mounted the mounting
hole covers must be removed.
1. Using a flat blade screw driver, insert the tip of the
screw driver in the slot between the back of the
cover and the unit.
2. Carefully lever the cover forward away from the unit.
3. Repeat steps 1 and 2 for the remaining mounting
hole covers.
Drilling out the mounting holes
When panel mounting the radio the mounting holes
must be drilled out.
Guides for the mounting holes can be found on the
corners of the unit, under the mounting hole covers.
30
81381-3-en-US_A5_PRINT.pdf 30 5/4/2020 3:26:31 PM