Specifications
Wired handset mounting using the
holster
Follow the steps below to mount the wired handset.
Before mounting, ensure that your selected location
meets the location requirements found in this document.
1. Check the selected location for the mounting holster,
a clear flat area is required, with sufficient space
around it to place and remove the handset.
2. Using a pencil, offer up the holster to the desired
location and mark the location of the screw holes
on the mounting surface.
3. Drill the mounting holes using a suitable size drill bit.
4. Hold the holster in place and secure using the
screws provided.
5. Place the handset into the holster until it clicks into
position.
Wired and wireless speaker mounting
Before mounting, ensure that your selected location
meets the location requirements found in this document.
1. Remove the speaker’s bezel.
2. Using the supplied mounting template, mark the
location of the cut out and fixing holes on the
mounting surface.
3. Using a 89 mm (3 ò in) hole saw, drill out the centre
cut out area indicated on the mounting template.
4. Drill holes for the fixings, using a drill with a suitable
sized bit.
5. Ensure that the unit fits into the removed area and
then file around the cut edge until smooth.
6. Peel the backing off of the supplied gasket and place
the adhesive side of the gasket onto the rear of the
speaker, pressing firmly onto the flange.
7. Connect the relevant cable to the speaker.
8. Slide the speaker into place and secure using the
fixings provided.
9. Fit the Bezel, ensuring it clips into place on all 4 sides.
Pass-through panel kit mounting
When installing handsets, the pass-through panel kit
should be used to secure the cable’s connector to the
panel the cable has to pass through.
1
Splash-proof dust cap with lanyard
2 Mounting plate fixings x 3
3
Mounting plate nut
4 Mounting plate
5 Mounting plate gasket
6
Extension cable
1. Check the selected location for the Mounting plate, a
clear flat area is required.
2. Ensuring correct orientation of the mounting plate,
offer up the plate to the desired location and mark
Installation 33
81381-3-en-US_A5_PRINT.pdf 33 5/4/2020 3:26:31 PM