User's Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Introduction
- 4 Description
- 5 Operation
- 5.1 Powering the meter
- 5.2 Auto/Manual range
- 5.3 Current measurements
- 5.4 Voltage measurements
- 5.5 Resistance measurements
- 5.6 Capacitance measurements
- 5.7 Frequency measurements
- 5.8 Type K temperature measurements
- 5.9 Continuity
- 5.10 Diode test
- 5.11 IR temperature measurements
- 5.12 MAX/MIN mode
- 5.13 Peak hold
- 5.14 Temperature units
- 5.15 Streaming measurement data using Bluetooth
- 6 Maintenance
- 7 Technical specifications
- 8 Technical support
- 9 Warranties
6 Maintenance
6.1 Cleaning and storage
Clean the meter with a damp cloth and mild detergent; do not use abrasives or
solvents.
If the meter is not to be used for an extended period, remove the batteries and
store them separately.
6.2 Battery replacement
1. To avoid electrical shock, disconnect the meter if connected to a circuit, re-
move the probe/thermocouple leads from the terminals, and set the function
switch to the
position before attempting to replace the batteries.
2. Unscrew and remove the battery compartment cover.
3. Replace the six standard AAA batteries, observing correct polarity.
4. Secure the battery compartment cover.
6.2.1 Disposal of electronic waste
As with most electronic products, this equipment must be disposed of in an envi-
ronmentally friendly way, and in accordance with existing regulations for elec-
tronic waste.
Please contact your FLIR Systems representative for more details.
#T559826; r.9072/9080; en-US 23