Quick Connection Guide

ManualsBrandsFlir ManualsSecurity Cameras640 X 480 Network Outdoor Thermal Imaging Camera with 7.5mm Lens, PAL

427-0089-00-28 Rev 160 June 2020

This document does not contain any export-controlled information.

FC-Series O, FC-Series ID Camera

Quick Connect Guide

Caution!

Except as described in this guide, do not disassemble the FC-Series camera.

Damage to the camera can occur as the result of careless handling or

electrostatic discharge (ESD).

Before installing the FC-Series camera you should read and understand the

following documents which provide details regarding mechanical dimensions

and installation safety.

• FLIR FC-Series O/ID Installation and User Guide (427-0089-00-12)

• FLIR FC-Series Interconnect Document (427-00XX-YY-41)

Power: Power Over Ethernet Plus (PoE+) or 11 - 32 Vdc or 18 - 32 Vac

Power terminal blocks: wire size from 16 AWG to 20 AWG

Analog Video Cable: BNC-terminated RG-59/U solid-center coax cable

Ethernet Cable: Cat5e or Cat6

Accessory I/O plugs: conductor size 22 - 24 AWG, stranded, 1.6 mm max

diameter including insulation for IDC fast connect. Otherwise, 20 - 24 AWG for

push-in spring connect, strip ends 6 mm. GPIO accessory cable.

FLIR Systems, Inc.

6769 Hollister Avenue

Goleta, CA 93117

USA

Support: https://www.flir.com/support/

Corporate Headquarters

27700 SW Parkway Ave.

Wilsonville, OR 97070

USA

Items Included in Kit

3 mm hex

Slotted

screwdriver

key

Summary of content (4 pages)

PAGE 1
FC-Series O, FC-Series ID Camera Quick Connect Guide Slotted screwdriver 3 mm hex key Items Included in Kit Caution! Except as described in this guide, do not disassemble the FC-Series camera. Damage to the camera can occur as the result of careless handling or electrostatic discharge (ESD). Before installing the FC-Series camera you should read and understand the following documents which provide details regarding mechanical dimensions and installation safety.
PAGE 2
Step 1 Remove cover: Using 3 mm hex key, loosen four captive screws. Access screws through slots in sunshield. Removing the sunshield is not necessary. Step 2 Install cables through sealing gland: Gland nut Video coax Accessory Fill any unused hole with orange plug. Re-tighten gland nut after installation is completed.
PAGE 3
Step 4 Connect a ground wire between the ground stud on the back of the camera and the nearest earth-grounding point. Step 5 Tighten Cable seal gland nut to ensure a watertight seal. Step 6 Replace cover: Alternately tighten the four captive screws in the cover; torque to 1.8 N-m (16.0 in-lbs). Step 7 Discover camera: Power the camera. With a PC connected to the camera network, use the DNA utility to discover and display the camera’s current IP address. a.
PAGE 4
takes more than 5 or 10 minutes, manual calibration may be required. Refer to the FC-Series O/ID Installation and User Guide. e. To create an Area, Tripwire, or Masking Area, click the select from the Type drop-down list. e. f. Define Areas, Tripwires, or Masking Areas by clicking vertex locations on the screen. g. Click Finish. icon and g. h. h. If defining a tripwire, select the tripwire in the Regions pane and set the direction of the detection from the Direction dropdown list. i.