Quick Installation Guide
Table Of Contents
- 1 Quick Install Guide
- 1.1 Check Contents
- 1.2 Select a Location
- 1.3 Connect the Camera
- 1.4 Configure for Networking
- 1.5 Mount the Camera
- 1.6 Connect the Camera
- 1.7 Aim the Camera
- 1.8 Check the Boresight
- 1.9 Configure the Analytics
- 1.10 Attach the Camera to a Supported VMS
- 1.11 Camera Dimensions
- 1.12 Register the Product
- 1.13 Contact Information
427-0102-00-28 Triton FH-Series QIG Rev 110
November 2021
This document does not contain any export-controlled information.
3 Connect the Camera
To install the camera, Teledyne FLIR recommends connecting the camera on a
bench or in a lab and configuring it for networking before mounting and aiming it.
However, circumstances can dictate adjusting the sequence of the steps. For
example, you can mount the camera before configuring it for networking, or
connect the camera before mounting it.
Warning
The camera itself does not have a power on/off switch. Do
not supply power to the camera until you have completely
finished connecting it.
The camera's interfaces and connections are inside the camera body. A microSD
card slot and reset / default button are located on a panel on the side of the
camera. To access the side panel, loosen and remove the screws that secure the
access cover. Before closing and locking the access cover, make sure to store the
anti-drop strap inside the camera to ensure that the camera remains waterproof.
Access Cover
Side Panel
Side Panel
1
LED status indicator—Solid green indicates
the camera is powered and operating.
·
To reboot and reset the camera to its
previously saved settings, press the
button for between 1-3 seconds.
·
To reboot and reset the camera to its
factory default settings, press the
button for at least 10 seconds.
2
Recessed Default / Reset button—To press
the button, Teledyne FLIR recommends using
a cell phone SIM or memory card tray eject
tool or something similar.
3
microSD card slot
The USB port is reserved for future use.
Important
Use a preformatted microSD card or format it with a single
partition using the camera's web page or a PC. For more
information about using the camera's web page to format a
microSD card, see the camera's installation and user guide.
Tip
Access the camera's web page, open the Recording page, and make
sure the camera recognizes the microSD card.
To open the camera's top cover:
a. Through slots in the sunshield, use the Torx wrench supplied with the camera
to loosen and remove the two screws that secure the camera's top cover that
are closest to the hinges. Then, loosen and remove the other two screws.