Quick Installation Guide
Table Of Contents
- 1 Quick Install Guide
- 1.1 Check Contents
- 1.2 Select a Location
- 1.3 Connect the Camera
- 1.4 Configure for Networking
- 1.5 Mount the Camera
- 1.6 Connect the Camera
- 1.7 Aim the Camera
- 1.8 Check the Boresight
- 1.9 Configure the Analytics
- 1.10 Attach the Camera to a Supported VMS
- 1.11 Camera Dimensions
- 1.12 Register the Product
- 1.13 Contact Information
427-0102-00-28 Triton FH-Series QIG Rev 110
November 2021
This document does not contain any export-controlled information.
You do not need to remove the sunshield to open the cover. Nonetheless, if
you want to remove the sunshield, loosen and remove the screws that attach it
to the camera body. Then, carefully remove the sunshield.
b. Open the camera cover to expose the inside of the camera body and the
following connections.
Camera Connections
Connection
Description
1
LAN (56V 1.6A)
PoE 802.3bt
Attach a Cat 6 cable from the network switch to the RJ45
port for 100/1000 Mbps Ethernet and PoE.
LED—Solid green indicates an active connection. Flashing
orange indicates data traffic between the camera and the
network.
2
BNC
x 2
T/V—Analog visible
or thermal video
output; supports
OSD
Attach to these connectors analog
video cables rated RG59U or
higher.
You can configure the video format
of the T/V connector and the on-
screen display (OSD) using the
camera's web page.
3
Analog thermal video
output; no OSD