Quick Installation Guide

427-0102-00-28 Triton FH-Series QIG Rev 110
November 2021
This document does not contain any export-controlled information.
If this is the first time you are configuring the camera or if it is the first time after
resetting the camera to its factory defaults, DNA automatically authenticates
the camera with the default password for the camera's admin user (admin).
If the admin user password has been
changed, you need to authenticate the
camera.
In the DNA Discover List, right-click the
camera and select Login.
In the DNA - Login window, type the
password for the admin user. If you do
not know the admin user password,
contact the person who configured the
camera's users and passwords.
Click Login, wait for Ok status to
appear, and then click Close.
In the DNA Discover List, verify that the camera's status is Authenticated.
b. Change the camera’s IP address.
Right-click the camera and select IP Setup.
In the DNA - IP Setup window, clear
Use DHCP and specify the camera's IP
address. You can also specify the Mask
(default: 255.255.255.0) and Gateway.
Then, click Update, wait for Ok
status to appear, and then click Close.
Close the Cover
Disconnect the camera.
Then, to prevent damaging the camera's internal components while moving it from
the bench or lab to its mounting location, close the camera cover and either re-
attach the sunshield or make sure to bring it to the mounting location.
At the mounting location, to connect the camera, remove the sunshield if
necessary and open the cover again.
5 Mount the Camera
Teledyne FLIR offers accessories to mount the camera on a wall, on a large pole,
on a small pole, in a corner, or on a pedestal. For more information about the
accessories required for each mounting option, see the camera's installation and
user guide.
Be sure to have the required accessories and tools available.