Quick Installation Guide

427-0300-01-10 Rev 130
June 2021
This document does not contain any export-controlled information.
e. You can select Static and manually specify
the camera's Hostname, IP address,
Netmask, and Gateway. You can also
specify the DNS Mode, Name Servers,
MTU (maximum transmission unit), and
Ethernet Speed.
f. Click Save. If you have made any changes on the Network page, the camera
reboots.
Note
For more information about configuring the camera for networking,
see the camera’s installation and user guide.
4.2 Configure and Test the Optional Wash Kit
If you have mounted and connected an optional wash kit, configure and test it and
the camera's wiper according to the kit's instructions manual and according to the
camera's installation and user guide.
Caution
Before activating the wiper, make sure the lens windows are wet.
Using the wiper when the windows are dry causes irreparable
damage to the window coatings and voids the warranty.
4.3 Attach the Camera to a Supported VMS
After you have mounted the camera and discovered or defined its IP address, use
VMS Discovery/Attach procedures to attach the camera to a supported VMS.