User Guide

This document does not contain any export-controlled information.
Installation
10
427-0300-00-12 - Revision 110 - May 2021
Warnings
· Make sure the camera’s power cable is properly connected. All electrical work must be performed in
accordance with local regulatory requirements.
· Use a UL Listed Power Adapter that meets LPS (Limited Power Source) requirements.
· Note the camera's maximum power consumption:
24 VAC (W)
LED
-40°C
25°C
60°C
Camera static
Off
N/A
21
21
On
27
43
43
PTZ motion
Off
N/A
29
26
On
57
50
49
Maximum, including
wiper and IRCUT
61
52
52
PoE (W)
LED
-40°C
25°C
60°C
Camera static
Off
N/A
15
15
On
35
32
32
PTZ motion
Off
N/A
22
19
On
41
37
39
Maximum, including
wiper and IRCUT
43
39
42
· A PoE injector should be connected only to a PoE network inside a building and not routed outside
the building.
· If the camera is installed outdoors with an external power supply, the power supply must be installed
with proper weatherproofing.
· A qualified service person should install the camera.
2.5 Waterproofing the Camera
The camera is IP66-rated to prevent water from entering the camera. Nevertheless, water can enter the
camera if it is not installed properly. Please make sure the warnings below are strictly followed when
installing the camera.
1. Place all cables and the adaptor in dry and well-waterproofed environments, e.g. waterproof boxes.
This prevents moisture accumulation inside the camera and moisture penetration into cables.
2. Seal the cable entry hole of
the pendant cap with the
rubber O-ring (supplied with
the camera) and use thread
seal tape to keep water from
entering the camera.
Waterproofing the Pendant Cap