Quick Connection Guide

427-0064-00-28 Rev 100 August 2017

FB-Series Camera

Quick Connect Guide

Caution!

Do not disassemble the FB-Series camera. Damage to the camera can occur

as the result of careless handling or electrostatic discharge (ESD).

Before installing the FB-Series camera you should read and understand the

following documents which provide details regarding mechanical dimensions

and installation safety.

• FLIR FB-Series Installation Manual (427-0064-00-12)

Power: Power Over Ethernet (PoE) or 12 Vdc or 24 Vac

Power terminal plug: wire size from 16 AWG to 20 AWG

Analog Video Cable: BNC-terminated RG-59/U solid-center coax cable

Ethernet Cable: Cat5e or Cat6

I/O terminal plug: not supported

FLIR Systems, Inc.

6769 Hollister Avenue

Goleta, CA 93117

USA

Support: http://www.flir.com/security/display/?id=71083

Corporate Headquarters

27700 SW Parkway Ave.

Wilsonville, OR 97070

USA

Items Included in Kit

Screws

Mounting

Power

template

plug

and anchors

Alarm

plug

Tor x

wrench

Tor x s c r ew

(spare)

427-0064-00-28 FB-Series Quick Connect.fm Page 1 Thursday, August 17, 2017 11:17 AM

PAGE 1
427-0064-00-28 FB-Series Quick Connect.fm Page 1 Thursday, August 17, 2017 11:17 AM FB-Series Camera Quick Connect Guide Torx screw (spare) Torx wrench Screws and anchors Alarm plug Power plug Mounting template Items Included in Kit Caution! Do not disassemble the FB-Series camera. Damage to the camera can occur as the result of careless handling or electrostatic discharge (ESD).
PAGE 2
427-0064-00-28 FB-Series Quick Connect.
PAGE 3
427-0064-00-28 FB-Series Quick Connect.fm Page 3 Thursday, August 17, 2017 11:17 AM Step 1 Mount camera. Warning! Before drilling into walls or ceilings for mounting the camera, verify that areas behind these positions do not contain electrical or other utility service lines. Serious injury or death may result from failure to heed this warning. a.To install the camera, place the supplied sticky back template in position. Slot for surface mounting cable b.
PAGE 4
27-0064-00-28 FB-Series Quick Connect.fm Page 4 Thursday, August 17, 2017 11:17 AM Step 3 Point camera. Setting the final scene view of the camera may require two people; one to view the video, the other to point the camera. Typically direct the camera towards the ground with a tilt angle α of 45° to 60°. Include as little skyline as possible in the field of view. α a.Loosen the base set screw in order to rotate the camera at the base. Base set screw b.