User Guide

427-1065-00-12 Revision 130 November 2019 46
This document does not contain any export-controlled information.
Advanced Configuration
Link Cameras on trk-101-P Tracker
Link the PTZ camera and the FB-Series ID from the trk-101-P web interface.
Step 1 Ensure that the FB-Series ID Analytics have been calibrated
(refer to Analytics Calibration, pg. 37).
Step 2 With the FB-Series ID Analytics turned off, login to the trk-101-P and set presets for the
bound PTZ camera and link the preset scenes to the FB-Series ID scene.
This process is outlined here and detailed in the FLIR ioi HTML Edition Units User Guide
which can be downloaded from the ioi Analytics section of the individual product web page
at https://www.flir.com/products/ioi-ptz-tracker/.
Step 3 Ensure that the FB-Series ID detection regions are setup to correspond to the presets on
the trk-101-P (refer to Creating Analytics Regions, pg. 40).
Step 4 Login to the trk-101-P web interface.
Step 5 Select Setup
Step 6 From the Camera > Type & Model screen, verify that the
Camera Model is configured as PTZ.
Step 7 Click Start PTZ Setup.
Step 8 On the Detection and Tracking screen, select Detection
from another camera with Automatic PTZ tracking. Click
Next.
Step 9 Click Calibrate and follow the instructions on the web
interface. Click Next.
Step 10 On the PTZ Synchronization screen, follow the procedure described in the FLIR ioi
HTML Edition Units User Guide. Refer to “Step 3: PTZ Synchronization with Fixed
Cameras” in the section “Using the PTZ Camera Definition Wizard”
Step 11 Set 8 correlation points on the ground for each camera, select Test, and then Link. Refer
to the procedure “To set correlation points in a preset” in the user guide. Click Next and
Finish.
Step 12 When finished, return to Live View and click Arm.
Select Fixed
Camera
Correlation
Points
Set 8 points
on both scenes