User Guide

Installing and Connecting the Camera

January 14, 2019

Ariel CB-3102 User and Installation Guide

Installing and Connecting the Camera

This section describes how to install and connect the unit. It includes the following topics:

 Pre-Installation Checklist

 Outdoor Mounting Recommendations

 Mounting Instructions

 Powering the Camera

 Connecting the Camera to the Network

 Resetting the Camera

5.1 Pre-Installation Checklist

Before installing the unit, make sure that:

 Instructions in the General Cautions and Warnings, Electrical Safety Notice, Minimizing EMI and

RFI, and Site Preparation sections are followed.

 All related equipment is powered off during the installation.

 Use best security practices to design and maintain secured camera access, communications

infrastructure, tamper-proof outdoor boxes, etc.

 All electrical work must be performed in accordance with local regulatory requirements.

Caution:

To avoid damage from overheating or unit failure, assure that there is sufficient temperature

regulation to support the unit’s requirements (cooling/heating). Operating temperature should

be kept in the range -40° to 50°C (-40° to 122°F), with no more than 90% non-condensing

humidity.

Attention:

Afin d'éviter tout dommage dû à une surchauffe ou toute panne de l'unité, assurez-vous que

la régulation de température est suffisante pour répondre aux exigences de l'unité

(refroidissement/chauffage). La température de fonctionnement doit être maintenue dans la

plage (-40° à 50°C/-40° à 122°F), sans condensation d'humidité supérieur à 90%.

5.2 Outdoor Mounting Recommendations

Following are additional considerations for outdoor installation:

 For outside wiring installation, always use weatherproof equipment, such as boxes, receptacles,

connectors, etc.

 For electrical wiring, use the properly rated sheathed cables for conditions to which the cable will

be exposed (for example, moisture, heat, UV, physical requirements, etc.).

 Plan ahead to determine where to install infrastructure weatherproof equipment. Whenever

possible, ground components to an outdoor ground.