Quick Installation Guide

ManualsBrandsFlir ManualsBullet Cameras8 Megapixel Outdoor Network IR Ultra HD Bullet Camera, 3.4-9mm Lens

Table Of Contents

Quick Install Guide

Ariel Gen III

CB-3304/CB-3308

4MP/8MP Bullet IP Camera

A. Use this QR Code

to access the FLIR Website

What's in the Box

Item

CB-3304

CB-3308

CB-330x Camera

1pc

Tapping Screw s (TP4

31mm)

3pcs

Plastic anchors

3pcs

T6 Torx w rench

1pc

1pcs

Drill template

1pc

1pcs

Quick Installation Guide

1pc

1pcs

Water proof cap

1pc

1pcs

Example - CB-3308-11

B. Download Camera Documentation

and Utility Software from the Web

C. Install the SD Card if required

Only required if Storage on the Edge is going to be used. (see User Guide)

A microSDXC card (not supplied) must be inserted in the card drive on the connector panel in order to locally store a snapshots or recordings triggered by events.

Insert a microSDXC card (Min 4GB, up to 128GB, Class 10) in the card drive.

After the camera is connected to the VMS:

1. Use the camera web page to verify that the card status is displayed as mounted in the System > Events Handler > SD Card screen.

2. Format the card. Card must be formatted as a single partition.

3. Configure the camera to store snapshots and recordings from the System > Events Source screens.

Summary of content (2 pages)

PAGE 1
Ariel Gen III Quick Install Guide CB-3304/CB-3308 4MP/8MP Bullet IP Camera A. Use this QR Code to access the FLIR Website What's in the Box Item CB-3304 CB-3308 CB-330x Camera 1pc 1pc Tapping Screw s (TP4 31mm) 3pcs 3pcs Plastic anchors 3pcs 3pcs T6 Torx w rench 1pc 1pcs Drill template 1pc 1pcs Quick Installation Guide 1pc 1pcs Water proof cap 1pc 1pcs B. Download Camera Documentation and Utility Software from the Web Example - CB-3308-11 C.
PAGE 2
D. Mount and connect the camera Be sure to have the required accessories and tools available. Refer to the User Guide as necessary. 1. Verify that the operating temperature range is between -20°C ~ 50°C (-4° ~ 122°F), 0-90% relative humidity (non-condensing). 2. Mount the camera at the site. 3. Use the RJ-45 socket to attach the camera to the VMS via a PoE 10/100 Mbps network switch (or use a PoE injector if connecting to a regular switch.) 4. Connect Inputs and Outputs if required (see table below) No.