Product Manual

FLIRCM55_CM57USERGUIDEDocumentIdentifier:CM55_CM57‐en‐US_AB
14
5.5DataRecordingandBluetooth®DataTransfer
5.5.1DataRecording
Whenprompted,thismetercanstorereadingsintoitsinternalmemoryautomaticallyforlater
transferoverBluetooth®(real‐timedatastreamingoverBluetooth®isalsopossibleasexplained
below)usingtheFLIRTOOLSapplication.Themaximumnumberofrecordsthatcanbestoredis
20,000andthefixedsampling(recording)interval
is1minute.

1. PresstheRECbutton>2secondstoentertheDataRecordMode.Thedisplaywillshow
theMemory
icon.
2. UsetheStart/Stopbutton
toStart/StopRecording.TheMemoryiconwillflashwhen
themeterisrecordingandwillstopflashingwhenrecordingisstopped. Thedisplaydigits
willshowthemeasuredreading.
3. Notethatafterone(1)startandstopcycle,storeddataiserasedwhenanewdata
recordingsessionisstarted.

4. Totransferallofthestoredreadingsinonebulkdatadumportodatastreaminreal‐
timeoverBluetooth®pleaserefertothefollowingsections.
5. PresstheRECbutton>2secondstoexittheDataRecordingMode.
6. NotethatDataRecordingcannotbeaccessed
whilethemeterisintheInrushmode.
7. DisabletheAPOutilitywhendatarecording.

5.5.2MeterIdentification(ID)Number
AuniquenumericalID(01‐20)canbeassignedtothemetersothat,whenmultiplemetersare
usedoverBluetooth®,eachcanbespecificallyaddressed.

1. WiththemeterOFF,pressboththePOWERandRANGEbuttonssimultaneouslyto
accesstheIDnumber.Thedisplaywillshow‘Idxx’.
2.
UsetheRANGEbuttontoincrementthe IDnumber.
3. Whenthedesirednumberisshown,pressthe
buttontosavetheIDnumberto
memory.
4. Powerthemeterdownandthenpowerbackup.
5. ThemeterwillnowberecognizedbyitsuniqueIDnumberonBluetooth®receiving
devices.