User Manual
Table Of Contents
- 1 Disclaimers
- 2 Safety information
- 3 Introduction
- 4 Description
- 5 Operation
- 5.1 Powering the meter
- 5.2 Auto/Manual range
- 5.3 Current measurements
- 5.4 Voltage measurements
- 5.5 Resistance measurements
- 5.6 Capacitance measurements
- 5.7 Frequency measurements
- 5.8 Type K temperature measurements
- 5.9 Continuity
- 5.10 Diode test
- 5.11 IR temperature measurements
- 5.12 MAX/MIN mode
- 5.13 Peak hold
- 5.14 Temperature units
- 5.15 Streaming measurement data using Bluetooth
- 6 Maintenance
- 7 Technical specifications
- 8 Technical support
- 9 Warranties
4 Description
The meter can measure DC current through the clamp jaws.
The meter can measure AC current through the clamp jaws.
The meter can measure temperature through the thermocouple
inputs.
The meter can measure IR temperature through the IR sensor.
The meter is in full power-saving mode
4.3 Function buttons
Press the button to change the operating mode for the currently
selected measurement.
• Use the button to select Auto range or Manual range mode,
see section 5.2 Auto/Manual range, page 14.
• In Manual range mode, press the button to change the range
(scale).
The Peak hold function is available when measuring AC/DC cur-
rent or voltage.
• Press the button to enter Peak hold mode, see section 5.13
Peak hold, page 21.
• Press the button to toggle between Pmax and Pmin modes.
• Press and hold the button for 2 seconds to return to normal
operation.
• Press the button to enter MAX/MIN mode, see section 5.12
MAX/MIN mode, page 21.
• Press and hold the button for 2 seconds to return to normal
operation.
• Press the button to enable/disable the display backlight.
• Press and hold the backlight/worklight button for 3 seconds.
Once released, the backlight will turn on. The same procedure
applies to disable.
#T559826; r. AE/ 10032/10032; en-US 11