CP-6408-31-I-Quick-Install-Guide

CP-6408-31-I QIG Rev 120
June 2021
This document does not contain any export-controlled information.
4.2 Change Video Format (Optional)
By default, NTSC is the camera's video format.
To change the camera's video format to PAL using the DNA tool:
a. In the DNA Discover List, right-click
the camera and select Change Video
Format.
b. In the Change Video Format
window, select PAL.
c. Click Update, wait for Ok status to
appear, and then click Close.
For more information about using the DNA tool to configure one or more cameras,
see the DNA User Guide. While the software is open, click the Help icon .
4.3 Configure and Test the Optional Wash Kit
If you have mounted and connected an optional wash kit, configure and test it and
the camera's wiper according to the kit's instructions manual and according to the
camera's installation and user guide.
Caution
Before activating the wiper, make sure the lens windows are wet.
Using the wiper when the windows are dry causes irreparable
damage to the window coatings and voids the warranty.
4.4 Attach the Camera to a Supported VMS
After you have mounted the camera and discovered or defined its IP address, use
VMS Discovery/Attach procedures to attach the camera to a supported VMS.