Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
106
Appendix F: Hard Drive Installation
Formatting the Hard Drive
After installing a new hard drive, you must format it before the system can recognize it.
To format a hard drive:
1. From Live View, right-click and select Main Menu>Adv
anced>HDD Management.
2. Under HD
D No., select the hard drive you would like to format. Information about the hard
drive appears in the lower section of the menu.
3. Under S
et to, select Format.
4. Click A
pply. Click OK to confirm. Wait for the hard drive to format. Hard drives become Read/
Write hard drives by default when formatted.
ATTENTION: Formatting the HDD erases
all data
on the hard disk.
This step
cannot be undone
. System settings will not be erased.
Select HDD
Select Format
Click Execute