Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
4
Rear Panel
REAR PANEL
1. DC 48V: Port for 48V DC power supply (included) for integrated PoE ports.
2. Po
E Ports: Camera input ports for IP cameras.
3. VIDEO OUT: Video
output (BNC) to connect the system to a secondary monitor.
4. USB por
t: Connect a USB mouse or connect a USB flash drive (not included) for data backup
or firmware upgrades.
5. MIC
:
• IN: BNC port f
or microphone (not included) for 2-way audio.
• OUT: BNC port for audio output device (e.g. speakers; not included) for 2-way audio.
6. LAN:
Connect an Ethernet cable (not included) to connect the system to a router or switch
(not included).
7. HDMI:
HDMI port to connect the system to a HDMI TV/monitor.
8. VGA
: VGA port to connect the system to a VGA monitor.
9. RS23
2: Service only; not in use.
10. ALARM IN
/ OUT / RS422-RS485: Alarm block to connect external alarm or motion devices
(not included).
• A/
B: Connection block for an RS485 PTZ camera (not included).
11. DC
12V: Port for 12V DC power supply (included).
12. Gr
ound
13. Powe
r Switch
10543 11 132 6 7 8 91
12