Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
12
Setting the Time
SETTING THE TIME
To set the date and time:
1. In the main viewing mode, right-click and click Main Menu. Log into the
system using the
admin account (default User Name is admin and Password is 000000).
2. Click Setting>Gener
al.
3. Enter the current date (MM DD YYYY) and time (HH MM SS) under Sy
stem Time.
4. Click Sav
e.
NOTE: T
o configure Daylight Savings Time see “General” on page 23. To configure NTP, see
“Configuring NTP” on page 26.
It is highly recommended to set the time on the system prior to doing any
recording.
Set the date and time
Click Save