Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
16
BACKUP
Backup video files to external USB flash drive (not included) or self-powered USB external hard
drive (not included).
Formatting the USB Device
It is recommended to format your USB device before using it with the system.
To format a USB device:
1. Insert a USB flash drive (not included) or USB e
xternal hard drive (not included) into one of
the USB ports.
2. From live view, right-click and then select Main Menu. Login if
prompted.
3. Click Backup.
4. Check the USB device you would like to format and click Er
ase. Click OK to confirm.
Backing up Video
1. Insert a USB flash drive (not included) or USB external hard drive (not included) into one of
the USB ports.
2. From live view, right-click and then select Main Menu. Login if
prompted.
3. Click Backup.
4. Check the USB device where you would like to save video.
Formatting the USB device will permanently erase all data.
Check the USB device
Click Erase