Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
20
Using the Main Menu
USING THE MAIN MENU
To open the Main Menu:
• U
sing the Remote Control or Front Panel Buttons: Press the Enter button twice.
• Using the Mouse: Right-click and click Main Menu.
NOTE: The
system password may be required to access the Main Menu. By default the User
Name is admin and the Password is 000000.
1. SE
ARCH: Open Search/Playback mode. For details, see “Search (Playback)” on page 14.
2. INF
O: View system information. Perform firmware upgrades.
3. SE
TTING: Configure general system, schedule, network, recording, display, and motion
settings. Restore system to factory defaults.
4. DEVICE
SEARCH: Connect IP cameras to the NVR.
5. AD
VANCED: Configure HDD, user accounts, and error functions. Configure auto-restart.
Save/restore system configuration. Access Manual Recording Menu.
6. BA
CKUP: Export files to USB device. For details, see “Backup” on page 16.
7. SH
UTDOWN: Logout, restart, or shutdown the system.
NOTE: Checkbo
xes on the system are filled in white when settings are enabled or empty when
disabled.