Instruction Manual

30
Using the Main Menu
activated, the system will cycle through
enabled views and a (arrows) icon is shown
on screen. You can click this icon to pause
Sequence mode.
• View 1/View 4/View 8/View 9/View 16:
Check to enable views to be shown in
Sequence mode. View 1 allows you to
enable/disable specific channels in
Sequence mode. Other View options allow
you to enable/disable views based on
pages. On 8-channel models for example,
View 4 #1 represents channels 1~4 and #2
represents channels 4~8.
NOTE: Available options depend on the
number of channels your NVR has.
• Dwel
l: Enter the Dwell time in seconds.
The Dwell time is the amount of time views
are shown on screen before changing in
Sequence mode.
• Motion Sequence Type: (8/16-channel
models only) Select the view type that will
be viewed when motion is detected.
2. Click Sav
e to save changes.
Default
The Default sub-menu allows you to reset the
system to factory default settings.
NOTE: Resett
ing to factory defaults does not
reset user accounts or passwords.
To reset the system to factory default
settings
:
1. Check the settings you would like to reset
t
o default settings.
2. Click OK.