Instruction Manual

31
Using the Main Menu
Device Search
The Device Search menu allows you to manage
connections to your IP cameras. SyncroIP
cameras connected to the PoE (Power over
Ethernet) Ports will automatically be detected
by your NVR. Device Search also allows you to
search for IP cameras connected to the LAN.
Some configuration may be required to
connect IP cameras from other
manufacturers.
NOTE: F
or a list of 3rd party IP cameras
supported, visit www.digimerge.com.
Adding Cameras from the LAN
1. Connect the camera to a router or switch
on the same network as the NVR.
2. Right-click and select Devi
ce Search. Log
in using the admin account (the default
User Name is admin and the default
Password is 000000).
3. Click IP Se
arch. The NVR scans your LAN
for compatible IP cameras.
4. Check the camera(s) you would like to add
and click Add.
5. If the Status indicator is green, the camera
is
connected and no further configuration
is required. Click OK to save changes.
6. If the Status indicator is red, click .
Update the following information, as
needed.
• Manuf
acturer: Select the manufacturer of
your IP camera.
• User: Enter the camera’s user name.
• Password: Enter the camera’s password.
• RTSP Port: Enter the camera’s RTSP Port.
• HTTP Port: Enter the camera’s HTTP Port.
NOTE: See the manuf
acturer’s user manual
for your IP camera for the default user
name, password, etc.
7. Click OK. C
lick OK again to save changes.
Manual Add
If the IP address of your IP camera does not
appear when you run IP search, ensure that
the camera is connected to the same LAN as
Check IP
Search
Check
cameras
Click Add