Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
34
Using the Main Menu
configure actions taken when system errors
occur.
To configure system error actions:
1. Under Ev
ent Type, select one of the
following system errors to configure: No
Disk, Disk Error, Disk No Space, Net
Disconnection, IP Conflicted, or MAC
Conflicted.
2. Check Ena
ble to enable warnings for the
selected Event Type.
3. Configure the following actions that will be
t
aken when errors occur:
• Sho
w Message: Check to show pop-up
window with information related to the
error.
• Send Email: Check to enable email
message. You must configure email alerts
before you will be able to receive them.
• Buzzer: Check to enable system buzzer.
4. Click Sav
e to save changes.
Record
The Record menu is used control manual
recording for connected cameras.
The Record menu is divided into the following
section
s.
• The Record Mode section defines settings
f
or the main (high quality) recording
stream.
• The Extra Stream section defines settings
for an optional lower quality recording
stream. This is useful because you can
record the Extra Stream to the hard drive
and stream it for playback to remote
devices. This saves bandwidth during
remote playback.
NOTE: Enabling Extr
a Stream Recording is
required to use playback mode on a
smartphone or tablet.
NOTE: R
ecording the Extra Stream will
increase the amount of disk space required
for recording.
To configure manual recording:
1. Right-click in live view and select Re
cord.
Log in if prompted.
OR
Click Main Menu>Adv
anced>Record.
Log in if prompted.
2. Under Rec
ord Mode, select the main
stream recording option under each
camera or under All to configure all
cameras:
• Sch
edule: Camera will record according to
settings configured in the schedule.
• Manual: When selected, the camera will
use continuous recording.
• Stop: When selected, the camera will not
record.
3. Under E
xtra Stream, configure recording
options for the Extra Stream.
4. Click OK t
o save changes.
Account
The Account sub-menu allows you to configure
user accounts. Accounts are organized into
groups, and receive permission to access