Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
46
3. Check Search.
4. Under De
vice, select the NVR you would like to search.
5. Under St
art Time and End Time, enter the start and end times for your search.
6. Click Sear
ch. A list of relevant alarms appears below.
Using Playback Mode
You can view recorded footage from your NVR’s in the CMS software.
To use playback mode:
1. Click Playback ( ).
2. Under De
vice, select the NVR and channel you would like to search.
• Check Multipl
e channel to playback video from multiple cameras. Select camera and then
click Add. Repeat to add additional cameras.
3. Under Pa
rameter, select the start and end time for the search.
4. Click Sear
ch.
Select alarm type
Check Search
Select NVR and channel
Enter start and end time
Click Search
Select NVR
Select Channel
Select search
parameters
Click Search