Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
48
FLIR SyncroIP NVR Central Management Software
2. Click Monitor Task.
3. Click Ne
w.
4. Enter a Ta
sk Name of your choice.
5. Under Wi
ndow, select the split-screen mode you would like to show in the task.
6. Under Mo
nitor Item, configure the following:
• Wi
ndow: Select the display window you would like to configure.
• Device: Click and drag the camera from the Device List in the main CMS window to the field
to add it.
• Stream Type: Select Main Stream or Extra Stream to view the sub-stream.
7. Click Ad
d. Repeat Steps 6 & 7 to configure additional screens.
8. Click OK. Cl
ick OK to save changes.
Configuring Projects
Once you have multiple tasks set up, you can configure projects to automatically cycle through
them.
To configure a project:
Click Monitor Task
Enter Task name
Select split-screen layout
Select display window
Drag camera from
Device List
Select Main Stream
or Extra Stream
Click Add