Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
51
7. Click Pic.
8. Click-and-drag the picture to the window to use it for the E-Map.
9. Click Devic
e to view a list of connected NVR’s.
10. Click + ne
xt to an NVR. To place cameras, drag cameras from the list to the map.
11. Click Sav
e.
NOTE: T
o delete all E-Map data, including images and camera positions, click Clear E-Map.
Opening Cameras from E-Map
Once you have configured your E-Map, you can use it to open cameras in live display.
To open cameras from E-Map:
1. Click E-M
ap ( ).
Click Pic
Home
Click and drag
picture to the window
Click Device
Click +
Drag cameras to
the map