Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
52
2. Click on a display area in the main CMS window, then double-click on the camera to open it.
Configuring the CMS
You can configure settings for the CMS such as the admin password, recording directories, and
start up settings through the Config menu.
Configuring CMS Options
1. Click Config( )>Options.
2. Configure the following:
• Ve
rify password: Check to require passwords when logging into or closing the CMS.
• Log in all devices: Check to allow the CMS to log into all NVR’s when it opens.
• Auto start record plan: Check to have the CMS automatically start the record plan, which
allows recording to the computer hard drive when it opens. To configure the record plan, click
Config Manager>Record Plan Config.
Click a display area
Double-click on a
camera to open