Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
64
Mobile Connectivity
Using Playback Mode on iPhone
You can access recorded video on your NVR using your iPhone.
NOTE: Y
ou must enable Extra Stream Recording to use playback mode on mobile devices. For
details on enabling Extra Stream Recording, see “Recording” on page 24.
To use Playback Mode:
1. From the Main Menu, tap Playback.
NOTE: If
Playback is not shown, tap Add, check Playback, and return to the Main Menu.
2. Tap +.
3. Select the start and end times to playback.
4. Select a channel to playback.
Tap +
Select start time
Select end time
Select channel