Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
65
Mobile Connectivity
5. Use the on-screen controls to control playback.
Enabling Push Notifications
You can have the app send push notifications to the notifications area on your device when one of
your cameras detects motion. Once you have received a push notification, you can select it to open
live video from the camera that detected motion.
NOTE: Y
our cameras must have motion detection activated to receive push notifications. For
details on enabling motion detection, see “Motion” on page 28.
To enable Push Notifications:
1. From the Main menu, tap Push Config.
NOTE: If Push
Config is not shown, tap Add, check Push Config, and then return to the Main
Menu.
2. For the NVR you would like to configure, set the slider to ON.
Double-tap to open in
full-screen
Select previous video file
Select next video file
Play/pause
Next frame
Fast
Slow
Push notification
Set to ON