Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
71
Mobile Connectivity
Enabling Push Notifications
You can have the app send push notifications to the notifications area on your device when one of
your cameras detects motion. Once you have received a push notification, you can select it to open
live video from the camera that detected motion.
NOTE: Y
our cameras must have motion detection activated to receive push notifications. For
details on enabling motion detection, see “Motion” on page 28.
To enable Push Notifications:
1. From live view, tap then .
2. Tap Alarm Push.
3. Set the slider to ON ne
xt to the NVR you would like to configure.
4. Tap Mo
tion Detect then check each channel you would like to receive push notifications from.
Push notification
Set to ON
Check each channel you would
like to receive push notifications
from