Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
73
Mobile Connectivity
4. Tap Device Manager.
5. Tap Add>Man
ually Add.
6. Configure the following:
• Name: Ent
er a name for your
NVR of your choice.
• Address: Enter your DDNS
address (e.g.
tomsmith.myddns-flir.com
).
• Port: Enter the Client Port
(default: 35000).
• Username: Enter the NVR’s
User Name (default: admin).
• Password: Enter the NVR’s
Password (default: 000000).
• Channel: Enter the number of
channels your NVR has.
7. Tap Sav
e.
8. Tap .
9. Tap Liv
e Preview.
Device Manager
Tap Add
Enter a name for
your NVR
Enter the DDNS
address
Enter the Client Port
Enter the user name
Enter the password
Enter the number of
channels
tomsmith.myddns-flir.com