Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
80
Mobile Connectivity
9. In landscape mode, tap a channel and then select the camera you would like to view on the
left. In portrait mode, tap + on one of the display areas and select the camera you would like
to open.
FLIR SyncroIP NVR HD Interface
You can use FLIR SyncroIP NVR HD in landscape or portrait mode.
Click + and then
select a camera
Double-tap to open
in full screen
Disconnect selected
channel
Add current
view to favorites
Snapshot
Change
display view
Slide to select favorites
Select different camera
Open configuration menu