Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
81
Mobile Connectivity
Using Playback Mode on Android Tablets
You can access recorded video on your NVR using your Android tablet.
NOTE: Y
ou must enable Extra Stream Recording to use playback mode on mobile devices. For
details on enabling Extra Stream Recording, see “Recording” on page 24.
To use Playback Mode:
1. From Live View tap then .
2. In P
ortrait Mode: Tap +, select the start time and end time for your search, and select the
camera you would like to playback.
OR
In Landscape Mode: Sel
ect the start time and end time for your search, and select the
camera you would like to playback.
3. Use the playback controls.
NOTE: Pla
yback controls are only shown in portrait mode.
Select start time
Select end time
Select camera
Pause/play
Previous file
Next file