Instruction Manual
Table Of Contents
- Basic Setup
- Front Panel
- Rear Panel
- Getting Started
- Remote Control
- Using the System
- Setting the Time
- Recording
- Search (Playback)
- Backup
- Using the Main Menu
- FLIR SyncroIP NVR Central Management Software
- System Requirements
- Prerequisites
- Installing FLIR SyncroIP NVR CMS
- Adding a NVR from the local area network (LAN)
- Adding a NVR using a DDNS address
- Using Alarm Rec (Event Search)
- Using Playback Mode
- Configuring Monitoring Tasks and Projects
- Using E-Map
- Configuring the CMS
- Adding User Accounts to the CMS
- Multi-Monitor Support
- Remote Viewing on Internet Explorer
- Mobile Connectivity
- Appendix A: System Specifications
- Appendix B: Setting up Remote Viewing
- Appendix C: Auto Port Forwarding Wizard
- Appendix D: Setting Up DDNS Service
- Appendix E: Remote Firmware Upgrade
- Appendix F: Hard Drive Installation
- Appendix G: Connecting an External Monitor
- Troubleshooting
83
Mobile Connectivity
4. Tap MotionDetect then check each channel you would like to receive push notifications from.
5. Tap OK. A
test notification will be sent to your device. After this, whenever the selected
cameras detect motion, you will receive a notification.
NOTE: Y
ou can see a list of notifications through the Event List menu. To show the Event List
menu, from live view, tap then .
Device Manager
Device Manager allows you to manage your NVR’s.
To access Device Manager:
1. From live view, tap then .
2. Tap De
vice Manager.
To delete an NVR:
1. Tap the NVR to select it.
Check each channel you would
like to receive push notifications
from
Tap on an event to view live
video from the camera