Installation Guide

421-0056-00-28 Rev 100 March 2019
This document does not contain any export-controlled information.
c. Enable the thermostat driver.
This enables rule 1, labeled DeIce. (Rule 0 is labeled DeFog.)
d. Scroll to the bottom of the page and click Save.
e. Restart the server: Click the green status
button next to Server Running once to stop
the server. After the server is stopped, click
the button (now black) again to start the
server.
Step 2 Expose the lens threads: Using the
spanner wrench, carefully unscrew
the factory-installed unwindowed
ring on the camera lens (pictured) to
expose the threads on the outside
rim of the lens. This ring is coated
with O-ring lubricant. Make sure
lubricant does not get on the camera
lens.
Step 3 Install the de-ice kit:
a. Using the spanner wrench, thread the windowed ring onto the lens.
Be careful not to cross-thread or damage the threads on the outside
rim of the lens.
b. When the windowed ring contacts the O-ring and turning encounters
more resistance, continue tightening for an additional half turn. This
ensures the window makes direct contact with the lens metalwork.
Failing to fully tighten the ring onto the lens reduces the heating
performance of the de-ice kit.
Select
Yes