Installation Manual

427-0089-00-12 Version 160 March 2019 50
This document does not contain any export-controlled information.
Advanced Configuration
tripwires. Each area/tripwire is assigned an Alarm ID number (1 to 8) based on the order in which
they are created and the available IDs. If an area is deleted, its Alarm Id will be available for reuse.
Analytics Calibration
• The camera must be mounted in its final location in order to calibrate the scene in the field of
view using either the auto or manual calibration tool.
• Analytics must be enabled to calibrate the scene.
• Set detection areas and tripwires.
• After calibration is finished, verify that the analytics detect and classify objects as expected.
Auto Calibration
If the scene is well ordered and without random motion from things such as trees, shrubs, or small
animals, and access is limited to people (the calibration target), then Auto calibration is a good
choice. Auto calibration relearning adjusts the detection size parameters as people (the calibration
target) are detected walking in all areas of the scene. The progress of the auto calibration is shown
as a percent in the top left corner of the image.
Note
Step 1 On the camera’s Analytics web page, click the
Calibrate icon.
It is recommended that cameras mounted sideways to use Corridor Mode should be calibrated
manually. Refer to Corridor Mode, pg. 49.
Add Areas
Calibration ToolsGlobal Settings
Figure 3-1: Analytics Page
Calibration
progress
1