Data Sheet
Table Of Contents
- 1 Advisories
- 2 Introduction
- 3 Safety
- 4 Descriptions
- 5 User Interface Menus
- 6 Powering the MR277
- 7 Moisture Measurement Operation
- 8 Thermal and Visible Camera Operation
- 9 Ambient Temperature and Humidity Measurements
- 10 Capturing and Working with Screen Captures
- 11 Bluetooth® Communication and FLIR Tools™
- 12 Field Firmware Updates
- 13 Maintenance
- 14 Specifications
- 15 Appendices
- 16 Limited 10–Year Warranty
- 17 Customer Support
User Interface Menus
5
Figure 5.29 Setting Bluetooth® ON or OFF in the Connections menu
• Radiometry & Moisture Alarms: Set the Radiometry (temperature) Alarm
to ABOVE, BELOW, or OFF. When a Radiometry alarm is set to ABOVE or
BELOW, the MR277 will alert you when the temperature exceeds the high
limit (temperature display turns red) or falls below the low limit (temperature
display turns blue). When a Radiometry alarm is set to OFF, the alarm is
disabled.
Set the Moisture Alarm to ABOVE or OFF. When a Moisture alarm is set to
ABOVE, the MR277 will alert you when the moisture measurement ex-
ceeds the high limit (moisture reading turns red and beeper sounds, if en-
abled). When a Moisture alarm is set to OFF, the alarm is disabled. The
Moisture alarm utility also allows you to select BEEP or NO SOUND for the
alarm alert. See Section 7.9 High Moisture Alarm and Section 8.4 High/
Low Radiometry Alarms for more information.
Figure 5.30 Setting Moisture and Radiometry Alarms
• Lamp and Laser Enable/Disable: Enable or disable both the Worklight
and Laser pointer. When enabled, press and hold the Worklight button
to
turn the Worklight ON or OFF. When enabled, press the Laser button
to
turn the Laser pointer ON (release the button to turn it OFF).
#NAS100005; r. AG/62027/62027; en-US
20