Data Sheet
Table Of Contents
- 1 Advisories
- 2 Introduction
- 3 Safety
- 4 Descriptions
- 5 User Interface Menus
- 6 Powering the MR277
- 7 Moisture Measurement Operation
- 8 Thermal and Visible Camera Operation
- 9 Ambient Temperature and Humidity Measurements
- 10 Capturing and Working with Screen Captures
- 11 Bluetooth® Communication and FLIR Tools™
- 12 Field Firmware Updates
- 13 Maintenance
- 14 Specifications
- 15 Appendices
- 16 Limited 10–Year Warranty
- 17 Customer Support
Moisture Measurement Operation
7
Moisture measurements are covered in detail in the following sections. Be
sure to select Pin Mode
or Pinless Mode in the ‘Moisture’ menu
to match the measurement type.
7.2 Moisture Display Options
View moisture readings in two basic ways. 1. Moisture readings as large digits
in the Moisture-only mode or 2. Moisture readings in small digits in the upper
left hand corner of a thermal or visible camera image. Choose the desired
mode in the menu (Image Mode). Refer to the information below and to Sec-
tion 5–4 Image Modes for additional details.
• Thermal MSX® mode (Multi-Spectral Dynamic Imaging). The digital cam-
era image is superimposed on the thermal image to give greater detail to
the thermal image. The moisture reading can be seen on the upper left.
See Section 5–4 Image Modes for aligning the digital camera image over
the thermal image (Alignment Distance Control).
Figure 7.2 Thermal MSX® mode with Moisture reading in the upper left corner
• Thermal Mode. This is the thermal image only. The moisture reading can
be seen on the upper left.
#NAS100005; r. AG/62027/62027; en-US
25