Data Sheet
Table Of Contents
- 1 Advisories
- 2 Introduction
- 3 Safety
- 4 Descriptions
- 5 User Interface Menus
- 6 Powering the MR277
- 7 Moisture Measurement Operation
- 8 Thermal and Visible Camera Operation
- 9 Ambient Temperature and Humidity Measurements
- 10 Capturing and Working with Screen Captures
- 11 Bluetooth® Communication and FLIR Tools™
- 12 Field Firmware Updates
- 13 Maintenance
- 14 Specifications
- 15 Appendices
- 16 Limited 10–Year Warranty
- 17 Customer Support
Moisture Measurement Operation
7
Figure 7.7 IGM™ mode with Moisture reading shown on upper left
In the IGM™ Custom mode , the same benefits apply to the discussion
above for IGM™ Moisture mode with the added benefits of displaying Air
Temperature, Relative Humidity, Vapor Pressure, Mixing Ratio, and Dew Point
Temperature on the camera image. To select which of these parameters to
display, use the Settings menu (Settings/IGM™ Custom).
For additional information see Section 5.5 Measurement modes.
Figure 7.8 IGM™ Custom mode with Moisture reading on upper left and Psychrometrics di-
rectly below
7.4 Moisture Measurement Modes
Press the Select
button to open the Main Menu, choose the ‘Moisture’
mode
, and then select from the four Moisture mode options as de-
scribed below.
• Material Groups
Select a Material Group that best matches the material under test. This ap-
plies only for external pin-based probe use. Use the menu to make a
#NAS100005; r. AG/62027/62027; en-US
28