User Guide

427-0075-01-12 Revision 140 October 2019 27
This document does not contain any export-controlled information.
Basic Operation and Configuration
Autofocus
This button causes the DLTV camera to toggle the autofocus mode. Clicking the button a
second time reinstates the autofocus mode and causes an autofocus operation. This
button causes the IR camera with a zoom lens to perform a one-time autofocus
operation.
Perform IR NUC Calibration—IR only—not present for PT-602CZ HD
This button causes the camera to do a manual Non-Uniformity Correction (NUC)
operation. The PT-Series HD camera, by default, does an automatic NUC calibration as
required based on changes in temperature. The PT-602CZ HD camera (cooled) does not
require a NUC operation.
Pan/Tilt Home
This button causes the camera to go to the Home position. To set a new Home position,
hold the button for approximately 3 seconds.
Electronic Stabilization On/Off—Visible only
This button enables or disables electronic stabilization on the visible video image.
Function—not present for PT-606Z HD
When the Function button is selected, the keypad changes to
a numeric keypad. A tool tip can be shown when a function
has been assigned to a number. Use the back ( ) arrow
to return to the Control Panel.
Go to Preset
The PT-Series HD camera can have a set of predetermined pan/tilt locations, each of
which is known as a preset. For example, a preset may be set for each of the locations
where security surveillance is most needed, a gate, doorway, and other points of access.
When the Go to Preset button is selected, the keypad changes to a
numeric keypad.
To cause the camera to go to a predefined location view (Preset) select a
number.
Use the back ( ) arrow to return to the Control Panel.
2.4 Camera Configuration
The following procedures describe how to do the most common camera configuration steps, such as
setting the camera IP address and hostname and changing the user passwords. To make these
changes, it is necessary to log in using the admin account.