User Guide

427-0075-01-12 Revision 140 October 2019 7
This document does not contain any export-controlled information.
PT-Series HD Camera Installation
• Shielded CAT6 Ethernet cable for streaming video, control, and for software updates. CAT5e
Ethernet cable may be adequate in many installations except when closely installed with power
cables in demanding video streaming networks.
• Serial cable for serial communications—optional
• Miscellaneous electrical hardware, camera mount (with stainless steel washers and bolts),
connectors, and tools
1.3 Location Considerations
Install the camera in a location that will allow access for regular periodic cleaning (fresh water rinse),
inspection of mounting integrity and mechanical soundness, and preventative maintenance. Ensure
the camera and the camera mount are routinely inspected on a periodic basis.
The camera will require connections for power, communications (IP Ethernet, serial), and video
(analog, IP digital).
• Ensure the 360° pan and 180° tilt exclusion zone is
free of all obstructions.
• Install all cameras with an easily accessible Ethernet
connection to support future software updates.
• Ensure that cable distances do not exceed the
specifications and that cables adhere to all local and
industry standards, codes, and best practices.
1.4 Bench Testing
Connect the power, video, serial, and Ethernet
connections and confirm that the video is displayed on a
monitor when the power is turned on. Confirm the camera
can be controlled by moving it (pan/tilt). For configuration
and basic setup information using the onboard web
server, refer to .
1.5 Camera Mounting
Galvanic isolation is critical in preventing corrosion. Proper installation of galvanic isolation pad and
washers is important for long product life.
There are two critical steps related to proper galvanic isolation camera mounting:
• Installation of galvanic isolation kit
• Proper grounding (bonding) to earth ground
1.5.1 Galvanic Isolation
The Galvanic Isolation Kit (FLIR PN 4204960) is for use with all PT-Series HD cameras. The
isolation plate and nylon shoulder or flat washers provide electrical isolation between the stainless
Ensure that the camera base is electrically isolated and properly grounded when it is secured to its
mount. Contact between the stainless steel fasteners and any bare aluminum may cause galvanic
corrosion which will shorten the life of the installation and may void the camera warranty.
Maximum keep-out cylinder
Diameter 25.5 in
17.4 in
high