Manual

115
APPENDIX H: REPLACING THE HARD DRIVE
The system comes with a pre-installed 2.5" SATA hard drive. The system supports up to 2
terabytes (TB) of SATA storage—2 x 1 TB 2.5" SATA HDD.
NOTE: Make sure that the
system is OFF and the power cable has been disconnected before
changing the hard drive.
Removing the Hard Drive
To remove the hard drive:
1. Remove the four screws on the side panels of the housing.
2. Carefully remove the housing, lifting from the
ba
ck of the unit, pl
acing it flat (see figure 34.0).
The hard drive is attached on a mounting plate.
NOTE: Make sure not to damage the cables
connecting
the fan to the circuit board.
3. Disconnect the cables from the hard drive.
4. Remove the four screws at the corners of the
mounting plate.
5. Remove the mounting plate (with hard drive)
from the
unit. Remove the four screws
below
the mounting plate and carefully detach the
hard disk.
NOTE: Make sure to keep the three sets
of
screws (housing, mounting plate, and hard drive)
in a safe place.
ATTENTION: Do not remove the two screws near the fan on the side of the housing, or
the two screws on the bottom of the unit.
Figure 34.0 Lift the housing from the back and lay
flat.